SKU 93297 For technical questions please call 1-800-444-3353. Page 3
Operation (Cont’d)
2.
The LCD readout will measure the distance between the pins or jaws as the
object is measured. Press the “Zero” button to set the readout to 0. The
LCD readout will show the measurement in either inches or mm. Press the
“Off button” to turn off when finished using.
3.
To change the setting from inches to millimeters, press the ON/Inch/mm
button. Each time the button is pushed the mode will change.
Measuring the Inside of an Object
1.
Set the prongs on the Caliper inside of the object being measured. Make
certain the Caliper readout is calibrated to “zero” while the prongs are
closed. Spread the prongs apart until they are touching the surface of the
object being measured. The LCD readout will show the measurement in
either inches or mm.
Replacing the Battery
1.
Remove the battery cover by gently prying it off.
2.
Replace the battery with the type specified on page two. Insert it into the
compartment so the positive and negative polarity match those indicated.
3.
Replace the battery cover. Dispose of the old battery in accordance
with local ordinances for proper disposal.
Maintenance
1.
Protect the Digital Caliper from rough use. It is susceptible to damage
from being dropped, struck with a test piece, improperly mounted or other
abuse. The precision movement is similar to a watch works, and should
be treated accordingly.
2.
Protect the Caliper from exposure to water or corrosive materials. It
should be kept clean and dry. Occasional cleaning with a clean rag will
extend its life and good appearance.
3.
Lock it up and store in a dry location to inhibit rust. Keep out of the reach
of children.
On/Inch/mm
Pins
Jaws
LCD readout
Figure 1
Prongs