Page 7
For technical questions, please call 1-800-444-3353.
Item 66817
Operating instructions
Read the EntiRE impORtant SaFEtY inFORmatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tool Set up
tO pREVEnt SERiOuS inJuRY FROm aCCiDEntal OpERatiOn:
make sure that all power Switches/triggers are in the off-position and unplug the tool
from its electrical outlet before performing any procedure in this section.
Operating instructions
1. Place the Power Inverter on a flat surface. Make
sure it has adequate ventilation and is not in direct
sunlight. Locate the Inverter close enough to the car
battery so that the Cables can easily reach between
the Inverter and the car battery. Position the Inverter
so that the Outlets are easily and safely accessible.
Make sure the Inverter is in the OFF position.
2. To connect the Cable Ring Terminals to the
(Positive) red and (Negative) black Power
Terminals on the back of the Inverter:
a. Unthread the knobs covering the Power Terminals.
b. Slide the red Cable’s Ring Terminal over
the post of the red Power Terminal and
the black Cable’s Ring Terminal over the
post of the black Power Terminal.
c. Replace the knobs and tighten securely.
3. Apply the parking brake to the vehicle connected
to the battery. Place the transmission in “Park”
for an automatic transmission, or in “Neutral” for
a manual transmission. Start the car engine.
4. Attach the red Cable’s Alligator Clip to the
Positive (red) terminal on the battery, then
attach the black Cable’s Alligator Clip to a clean
unpainted metal part of the chassis. (Note: If
connecting to a battery not installed in a vehicle,
connect to the Negative (black) terminal.)
5. The red Fault LED will light up momentarily and
the alarm will sound as the Inverter draws power.
Then the alarm and red LED will turn off and the
green Power LED of the Inverter will light up.
note:
If the green LED fails to light and the alarm
and red Fault LED lights up instead, check the
Troubleshooting Tips section near the end of this
manual to correct the issue before continuing.
6. To power each device or appliance:
a. With the device or appliance switched off,
plug it into one of the Power Outlets or
the USB Outlet on the Power Inverter.
b. Turn on the device and/or appliance.
7. After use, turn all connected devices or appliances
off, unplug them, then turn off the car engine if it is
running. Keep the inverter turned on and remove
the alligator clips from the battery posts, removing
the Negative (black) clip first, then the Positive (red)
clip. The Inverter green LED will turn off, and the
alarm and red LED light will turn on as the Inverter
powers down. Turn off the Inverter power button.
Sa
FE
tY
Op
ER
ati
O
n
m
aint
Enan
CE
SE
tup
