Page 8
For technical questions, please call 1-888-866-5797.
Item 37772 61593
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
General Operating Instructions
Ac Voltage Measurements
Measure AC conductors carrying
up to 700 VAC, 45-450 Hz.
1. Turn the Range Selector Switch to
700 ACV setting. Start with the highest
range if the voltage is unknown.
2. Plug the red lead into the V/Ω/Hz Jack.
Plug the black lead into the COM
Jack. Switch the Multimeter ON.
3. Carefully touch the exposed
conductors with the tips of the probes
to measure the voltage (not amperes).
4. Read measurement. If the voltage is
less than 200 volts, set the Range
Selector Switch to the lower range.
5. When testing is complete, remove
Test Leads and store with multimeter.
Dc Voltage Measurements
Measure DC conductors
carrying up to 1000 VDC.
1. Turn the Range Selector Switch
to 1000 DCV setting.
2. Follow the directions above under
“AC Voltage Measurements”, only
use the DC settings instead.
Ac current Measurements
Measure AC conductors carrying
up to 20 amperes.
1. Turn the Range Selector Switch to the
20A~ position. Start with the highest
range if the amperage is unknown.
2. Plug the red lead into the 20A
Jack. (For current under 20A, plug
the red lead into the mA Jack.)
Plug the black lead into the COM
Jack. Switch the Multimeter ON.
3. Carefully touch the exposed
conductors with the tips of the
probes to measure the amperage.
Note:
Amperage is always tested in
series with the circuit under test.
4. Read measurement. If the reading is
less than 0.2 amps, switch the red lead
to the VΩmA Jack and set the Range
Selector Switch to the 200 mA setting.
5. When testing is complete, remove
Test Leads and store with multimeter.
Dc current Measurements
Measure DC conductors
carrying up to 20 amperes.
1. Turn the Range Selector Switch to the
20A position. Start with the highest
range if the amperage is unknown.
2. Follow the directions above under
“AC Current Measurements”, only
use the DC settings instead.
