Belt & Agitator Changing/Replacement
Agitator Cleaning
To Clean Agitator
NOTE:
In order to keep cleaning
efficiency high and to prevent
damage to your powerhead, the
agitator must be cleaned every time
the belt is changed. The agitator
must also be cleaned according to
the following schedule.
Vacuum Cleaner Use
HEAVY -
(used daily)
MODERATE -
(used 2-3 times/week)
LIGHT -
(used 1 time/week)
Clean Agitator
every week
every month
every 2 months
IMPORTANT
Disconnect powerhead from
electrical outlet. Check and remove
hair, string and lint build-up
frequently in the powerhead agitator
and end cap areas.
Remove any dirt or debris in the belt
path area or in the brush roller area.
Carefully remove string or debris
located on the agitator or end caps.
1) Turn the nozzle upside down
and locate the belt plate shown
below.
2) Turn the locking mechanism
counter-clockwise to the
unlock position and remove
the belt plate from the nozzle.
3) Lift the agitator on the belt
connected end.
4) Pull the belt off of the
agitator and remove the
agitator from the nozzle.
5) Remove the five screws
from the bottom of the nozzle
located below.
7) Remove the light gray cover
plate shown below.
8) Carefully lift up the axel
holding the belts and remove
the axel and agitator belt.
9) Lift up the motor to replace
the second belt.
Agitator
Belt
Screws
Cover Plate
Axel
Belt
Motor
Belt
End Cap
Belt Path
Brush Unit
End Cap
Agitator Assembly
Belt Plate
6) Turn the nozzle over and
remove the top casing.
10) To put the nozzle back
together follow the steps in
reverse order (9 to 1).
To Replace Belts
To Replace Agitator
