CEN Racing 1/12 Series, Instruction Manual

Page: 10 / 24

9
CQ0409
Transmission Bracket
G36533
M3x12mm RHTP
G36538
M3x18mm RHTP
G36533
M3x12mm RHTP
G36226
M3x6mm Cap
CQ0219
Transmission Gear Box B
G36701
2x10mm Pin
G36403
M4 Nylon
Locknut
CQ0223
85T 48P Spur Gear
★
Use Threadlocker
★
G73935
5x10mm
Thrust Bearing
CQ0247
Slipper Spring
☆
Use Grease
CQ0246
Slipper Hub Set
CQ0225
Slipper Pad
G36221
M3x8mm Cap
☆
☆
☆
Caution:
The base factory settings are set for a starting point to obtain your slippage which are just enough to protect your drivetrain from
heavy throttle loads.
*Do not set the slipper clutch too tight as this may cause risks of damaging the transmission, as well not too loose as the car will
have a lack of performance which may cause risks of damaging the slipper clutch system.
Recommended Slipper clutch adjustment: First, place the 2.0mm Allen wrench tool (included) into the center drive cup horizontally
through the drive cup where the dog bone pin sits and hold by hand to lock the transmission.
Second, tighten the slipper adjustment nut (clockwise) by using 7mm hex driver or (the 4-way tool included) until it stops then
loosen it counter-clockwise 1 1/4 turns.
*From here tighten or loosen your slipper no more than 1/8 of a turn at a time and test again to obtain your optimal slippage for
your application.
Upper Plate
5x9.8mm
Lower Plate
5.2x10mm
Pay attention to direction
☆