Cembre B-FL750ND, Operation And Maintenance Manual

Page: 7 / 36

7
ENGLISH
WARNING
Do not use the tool for purposes other than those intended by
Cembre
.
The operator should concentrate on the work being performed and be careful to maintain a balanced
working
position.
Before each use check the punches, dies and draw studs, and replace any that are worn or damaged,
particularly any punches that have damaged cutting surfaces.
Damaged or improperly assembled accessories can break and hit the operator with suffi
cient
force to cause serious injuries.
Before each use, verify the integrity of the tool; replace any worn, possibly damaged or missing
parts with original
Cembre
spares.
Only for use when punching holes in single layer material and thickness as shown in the tables on
pages 31 and 32. Any other use may cause components to break with potential risk of serious injury.
During operation do not allow anyone else to stand in the work area, especially in front of the punch.
The use of
Cembre
punching accessories is recommended. Accessories from other suppliers may
not be designed to withstand the force generated by this tool and may be damaged or break with
potential risk of serious injury.
Protect the tool from rain and moisture. Water will damage the tool and battery.
Electro-hydraulic tools should not be operated in pouring rain.
2. INSTRUCTIONS FOR USE
The part reference includes the following:
Hydraulic tool.
Li-Ion rechargeable battery (2 pcs).
Battery charger (model depends on the tool version).
Shoulder strap.
Carrying case.
ø 11.5 mm Spiral bit (code 6134070).
TD-11 Draw stud with threaded 7/16"-3/4" (code 2685005).
TD-19 Draw stud with threaded 3/4"-3/4" (code 2685008).
USB cable (Ref. to § 5).
2.1) Preparation
The tool can be easily carried using either the main handle (6) The tool can be easily carried using either the main handle (6)
or the shoulder strap attached to the two eyelets of the wrist
strap (8) (Ref. to FIG. 6). The tool can be held in one hand while
positioning the punch with the other.
Before starting any work, check the battery charge
(Ref. to § 2.7) and recharge if necessary, following the
instructions in the battery charger user manual.
To
replace the battery, remove it by pressing the release
button (7), then insert the new battery, sliding it into the
guides until it locks.
Battery
7