CELTIPOL CHL-350, Technical Manual

Page: 41 / 61

41
CHL-350 TECHNICAL MANUAL
03-2021
Translation of the original manual
17. SELECTING WORK TEMPERATURE.
Using the temperature controllers on each product ( f,j ) and on the hose ( l ) (EMKO ESM 4420) ,
the ideal temperature can be selected depending on the products to be used and the projection
work to be carried out. (The controllers are factory set with the factory temperature selected
according to customer requirements).
In order to select the required temperature, follow these steps:
1. Press PSET on the controller appearing on the PSET function screen.
2. With the keys
 
the temperature range is increased or decreased.
3. Once the ideal temperature has been set, press ASET to keep the selected value,
resetting the controllers screen to its initial status.
18. SELECTING WORK CYCLE.
Celtipol machines can be fitted, if required by the customer, with a cycle counter ( e ) with
preselect and with the possibility of blocking when the machine reaches the end of the cycles
indicated.
This cycle counter ( e ) can perform two functions:
1. Only count cycles when the machine is not stopped.
2. Count cycles and blocking the machine when following the programmed cycles.
1.
Do not start up the
system without material
in the pumps or tanks.
2.
Do not unscrew
the loose nut on the
gun with the
machine in
3.
Do not connect
the heaters without
products.
4.
The operational temperature will
vary depending on climatic
conditions or the reaction of the
different brands of the products.
5.
Where necessary to alter the length of the hose, it
will be necessary to first alter the output voltage of
the transformer (Consult the Technical Assistance
service).
6.
Do not open the taps on
the products without first
opening the air stopcock (on
the gun).
7.
Do not place any part of
the body in the direction of
the projection nor project
towards other people.
8.
It is advisable to use protective goggles, air mask,
protective clothing and other safety equipment.
Manufacturers’ recommendations and the instructions
for the products used should be followed.