Celsus MRA-470D Quick Start Manual Download Page 5

www.celsusice.co.uk

 

www.celsusice.co.uk

 

 

(Point 6 continued…) The RCA adaptor harness Power, 
Ground & Remote connections can only be used with the 
Celsus BTC10-001 and must not be used with any other 
product.  
 
The Amplifier can be damaged by connecting the RCA Adaptor 
harness Power, Ground & Remote to any other product (other 
than BTC10-001) and will not covered by warranty.  
 
If the Amplifier is to be connected to another product (not the 
BTC10-001) then the Power, Ground & Remote must not be 
connected to the RCA Adaptor harness and an alternative 
power source located (i.e. the battery) and the Remote input 
connected to the Blue wire that is part of the “main amp supply 
harness”. 
 

7. 

Power up system & check the control panel setting. (section G) 

 
 
For troubleshooting see end of manual. 
 
 
 
 
 
 
 
 
 
 
 
 

G.)

 Control Panel Settings & Adjustments 

 
The amplifier’s settings and controls are located on the side panel 
beneath a gasketed, protective cover. Remove the five Allen head 
screws from the centre panel to access the controls and make 
adjustments. Replace cover when finished and secure amplifier. 
 
Amplifier set-up and gain adjustment is critical to a great sounding 
audio system and should be undertaken by an experienced 
specialist. This will avoid distortion and potential damage to your 
speakers. 
 
Power/ Protect Indicator 
This indicator will light up RED upon initial amplifier start up. If all 
connections are ok, within 3-5 seconds the light will turn BLUE. If a 
condition of protect (short circuit, over/ under voltage) occurs the 
light will turn RED until the condition of protect is resolved. 
 
Control Panel settings 
The control panel settings required on the amplifier depending on 
the system design (speaker / subwoofer configuration. 
 

This amplifier can be used in three modes  

 

4 stereo loudspeakers 

 

2 stereo loudspeakers (Bridged front & rear channels) 

 

2 stereo loudspeakers and 1 subwoofer (Bridged Mono 
rear output) 

 
Always check compatibility of the equipment being used. Your 
speakers / subwoofer must be able to handle the continuous power 
of the amplifier.  
 

Reviews: