( LOGO)
DESK AND WALL-MOUNTED ELECTRIC FIREPLACE/HEATER
BFM EUROPE LTD
Page 2
IMPORTANT
This appliance can be used by children aged from 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they have been given supervision
or instruction concerning use of the appliance in a safe way and understand the hazards involved!
Children shall not play with the appliance!
Cleaning and user maintenance shall not be made by children without supervision.
Warning: Electrical Plug must be completely inserted into the 16A electrical socket to avoid the risk of
overheat problem.
Children of less than 3 years should be kept away unless continuously supervised.
Children aged from 3 years and less than 8 years shall only switch on/off the appliance provide that it
has been placed or installed in its intend normal operating position and they have been given supervision
or instruction concerning use of the appliance in a safe way and understand the hazards involved.
Children aged from 3 years and less than 8 years shall not plug in,regulate and clean the appliance or
perform user maintenance.
PLEASE READ THE INSTRUCTIONS CAREFULLY BEFORE INSTALLATION
AND/OR USE OF THIS ELECTRIC FIRE AND RETAIN FOR FUTURE REFERENCE.
WHEN USING ELECTRICAL APPLIANCE, BASIC PRECAUTIONS SHOULD ALWAYS BE
FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK AND INJURY TO PERSONS,
INCLUDING THE FOLLOWING IMPORTANT SAFETY ADVICE.
READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE.
Regarding installation of the appliance;
· This appliance is supplied with a rewirable plug fitted with
a 13A fuse. Should the fuse or plug need replacing, and
you are competent to do so, it must be replaced with a
13A fuse and the plug muse be a 13amp BS1363A
approved fitted with a 13A fuse.
· Connect this appliance to single-phase AC supply of the
voltage specified on the rating plate.
· This heater must be earthed. If in any doubt consult a
suitable competent person.
· Ensure that the plug socket-outlet connection for this appliance is accessible.
It MUST be readily accessible for easy electrical isolation in the event of servicing and replacing
components etc.
· This appliance MUST NOT be located immediately below an electrical socket-outlet.
· Avoid the use of an extension cord as this may overheat and cause a risk of fire.
· Running this appliance on heat setting 2 (2000W) with another piece of electrical equipment on the
same circuit may cause the fuse of this appliance to blow, or you circuit breaker to turn off the power
supply. If this occurs reconnect one of the appliances to another circuit.
· This appliance is fitted with an automatic thermal cut out to reduce the risk of damage in the event of
abnormal operation e.g. when covered. If the heater stops operating whilst the flame effect continues
normally this indicates that the cut out is in operation. If this occurs disconnect the power supply at
the plug socket-outlet and ensure that any obstructions to the fan heater outlet or fan blades etc. are
removed. The heater will automatically reset when cool enough. The thermal cut out WILL NOT
IMPORTANT INSTRUCTIONS
