3
Cellphone-Mate Inc.
CM700A Manual
STEP 5. Connect the Power Cord.
STEP 6. Turn the Power Switch on
Warning: To prevent damage to the Amplifier, before you plug in the Amplifier to an AC power outlet,
please make sure that both sides are already connected with the cables from both the outdoor and
indoor antennas.
WARNING: after the power is turned ON, and before making any cellular phone calls, if the
warning light is ON, oscillation is happening. POWER OFF immediately, then reduce both
the uplink gain and downlink gain via the gain control switches on the side panel, or further
increase separation distance between the two antennas, or do both until the power warning
light is not ON when you are not making cellular phone calls.
Note: 1. Power lights will always be on after you power up.
STEP 7. After solving all oscillation problems, users can make cell phone calls to test how the repeater system works,
adjusting the gain using attenuator as needed.
Safety Warning:
1. Never plug in the power supply to the amplifier without attaching the outdoor antenna and indoor antenna to the amplifier.
2. Ensure that the distance between inside and outside antennas is a minimum of 100 feet from the amplifier.
3. If the Warning Light is on when you are not making cellular phone calls, DO NOT use the amplifier, turn it off immediately,
since it may cause damage to the amplifier.
TROUBLESHOOTING GUIDE
During operation, if the Amplifier interferes with your radio or other electronic receivers, move the Amplifier further away from those
devices.
For a list of Frequently Asked Questions and a complete and up-to-date Troubleshooting Guide, please visit our website at:
www.Cellphone-Mate.com
You can also consult a Cellphone-Mate technical specialist directly by sending e-mail to us at:
Or write to:
Cellphone-Mate, Inc.
48820 Kato Rd. Suite 300B
Fremont, CA, 94538 U.S.A.
Power Light
Warning Light
