20’ x 40’ Pinnacle Series High Peak Frame Tent/Cross Cable Marquee
GetTent.com/CelinaTent.com/GetTent.co.uk
PG.7
© 2018 Celina Tent Inc.
SAFETY
MAINTENANCE
INS
TALLA
TION
CONT
AC
TS
INSTALLATION INSTRUCTIONS
Set Up Instructions
1. Lay out a drop cloth in the area the tent will be installed to protect the tent top of dirt and abrasions.
2. Lay out the frame parts on the ground in the approximate location that they will be when the frame is
assembled. (See parts/minimum staking layout diagram)
3. Starting at a corner, insert the spreader bar (9’3” connected tube) into the corner fitting and the side tee fitting.
4. Continue to insert all spreaders into the corner fittings and side tee fittings until a rectangle is formed.
5. Connect one cross cable to the inside hook on the corner fitting. Connect the other end of this cable to the
hook on the side tee fitting at the diagonal corner.
6. Connect the second cross cable to the remaining corner fittings and side tee fitting in the same way. Do this
for all remaining cross cables.
a. In order to fit the cable onto the 4th corner fitting hook, you may need to lift the frame up on that
corner approximately 4 feet. This reduces the distance between the corners allowing the cable to reach
the 4th corner fitting hook.
7. Lay the tent top out over the cables and frame with the top of the tent facing upward. Start in one corner by
securing the white nylon strap over the ring on the outside of the corner fitting & around the side tee fittings.
Please note that the strap on the side tee fitting is wrapped completely around the bottom of the cast fitting
where the side pole is inserted. It does not hook over the tie back ring like the corner fittings.
a. Continue to secure all the tent corner & side straps to the outside corner fittings. Make sure the strap
with the O ring is the last strap to be secured. This ring and strap will allow for better grip when
securing the top over the last fitting.
Corner Fitting
Side Tee Fitting
