Quick Start
1. Place the CD into your computer’s
CD-ROM drive.
2. Install both the NexImage iCap and
RegiStax software onto your computer.
3. Thread the 1.25” nose piece into the body
of the NexImage camera.
See Fig 2.
4. Slide the 1.25” nose piece of the camera
into the eyepiece barrel of your telescope.
See Fig 3.
5. Plug the small end of the USB cable into
the port on the back of the camera.
6. Plug the other end of the USB cable
into a USB port on your computer.
Once connected, the Found New
Hardware message will appear. Follow
the Installation Wizard until the device
has been successfully installed.
Congratulations on your purchase of the Celestron NexImage Burst
Solar System imaging camera.
Your NexImage camera comes with the following:
+ NexImage Burst Camera
+ 1.25” nose piece
+ CD including NexImage iCap and RegiStax processing software
+ USB Cable
Recommended Minimum System requirements:
+ Pentium IV, 2.0 GHz, 1GB RAM
+ Graphics card with 24 or 32 bit
+ Windows XP, Windows Vista, Windows 7 (32 & 64 bit)
+ DirectX 9.0c or higher
1.25”
Nose Piece
USB Cable
NexImage Burst
Camera
NexImage iCap and
Registax processing
software
Fig 1
1
2
Fig 2
Fig 3
