Celect CC908XWHB-7-DF1, Manual, Page: 10 / 12

10
In normal operation, press ▲ or ▼ ,
“temporary hold”
is flashing indicates thermostat is in temporary
hold mode. Press ▲ or ▼ to change set temperature, the thermostat will override the current programming
setting and keep the room temperature at the selected temperature until the next program period begins. Then
the thermostat will automatically revert to the program operation. Press ④ quit .If no keys are pressed
within 20 seconds, the thermostat will revert to using schedule.
2. Permanent hold temperature setting
When thermostat is in program operation, press butto
n ①
over 3 seconds to enter the Permanent hold
mode . Press
▲、▼
change set temperature. The thermostat will permanent hold the room temperature at the
selected setting until you press
④
button to restart the program operation.
3. Code match and Wireless Control
：
1) According to the system requirements CC2010DE connected to the power source (L, N 100 ~ 240 vac),
Check and energizing, Press the power button switch machine is normal or not electricity, light is lit.
Otherwise, Please replace the product, Then press the last step action to execute.
2) Open CC908XWHB-7-DF1 backplane Load two batteries (AA)
， Closed the backplane, And check the
display and button functions, not normal replacement product, Press re-execute the previous step action.
(3) Energized normal CC2010DE products in shutdown mode (indicator), press and hold the power button
until the indicator A long bright yellow release, this time CC2010DE in the code state.
(4) The thermostat CC908XWHB -7- DF1 in standby mode, long according to the thermostat
R
button more
than 3 seconds, Emission to code command.
(5) The success of the code receiving portion yellow flashing 01 blinks four times, Otherwise the code is
unsuccessful, Return reflector of the original code value.
Note: When in the process for the debug on/off, the interval of time should more than 4 sec,
otherwise the products have not time for react.
4. Reset operation
If the display is abnormal, press the Reset button by using a fine probe such as a straightened paper
clip to gently push the Rest button. This will reset the thermostat.
5.
Battery note
: 1)The battery power low battery warning sign " " flicker
2) Products when not in use for a long time, please take off, to prevent battery leakage
damage product