Page 3 of 5
OPERATION
Commissioning
No commissioning is required when the thermostat and the receiver have been supplied in the
combined pack because they have been paired in the factory. User can make commissioning again
by following steps for any possible reason.
STEP 1: Wire the SAS2010DE receiver, switch off the receiver and hold the power button for 3
seconds until the yellow light is on.
Figure 6
Power Button
Light A (RED / GREEN LED)
Light B (GREEN LED)
Light C (YELLOW LED)
STEP 2: Rotate the setting knob of the RF thermostat till 5
℃
shows in the display.
STEP 3: Remove the dial, press and hold the LEARN button for 3 seconds. When the yellow light
flashes in the receiver and thermostat’s display shows 01, the thermostat and the receiver have
successfully been paired.
ON OFF
Hidden code button
Rotary disk
installation diagram:
