Celcia MDT3-10DEN3, Instruction Manual

Page: 69 / 75

MDT3-10DEN3 MDT3-10DMN3
67
6. Parts Identification / Installation / Assembly / Drawings
CONTROL PADS ON THE DEHUMIDIFIER
-QA3
Indicator light Control pads
1
Power on indicator light (green)
2
Bucket full indicator light (red)
3
Continuous operation on indicator light (green)
4
Display
Shows the actual room % humidity level in a range
of RH15% to RH 99%.
Shows the set % humidity level while setting, then
the set value flashes at 2Hz for 5 seconds, then
shows the actual room % humidity level.
Error Codes:
E1 - Humidity sensor error--Unplug the unit and plug
it back in. If error repeats, call for service.
E2 - Temperature sensor error-- Unplug the unit and
plug it back in. If error repeats, call for service.
P1 - Unit is defrosting-- Allow the unit time to automatically
defrost. The error will clear after the unit self defrosts.
P2 - Bucket is full-- Empty the bucket and replace in
the right position.
5
POWER Pad
Press to turn the dehumidifier on and off.
The power indicator light blinks at 0.5Hz
when the power is connected. And it
illuminates(green) when the unit is
switched on and turns dark when the
unit is switched ff. When Humidity/
Temperature sensor malfunction
occurs, it blinks at 5Hz.
6
Humidity Set Control Pads
The humidity level can be set within a
range of 35%RH(Relative Humidity) to 80%
RH(Relative Humidity) in 5% increments.
For drier air, press the pad and set to a
lower percent value(%).
For damper air, press the pad and set to
a higher percent value(%).
7
Continue Pad
Select for the dehumidifier to operate
continuously for maximum dehumidification
until the bucket is full. The Humdity set
control pads cannot be used when
Continuous operation is on.
Full Power
Full Power Cont .
Power
Dehumidify operation on indicator light(green)
8
1
2
3
4
5
6
7
1
2
5
3
Cont.