CEL Power8 workshop, User Manual, Page: 65 / 86

Know Your product
4.1
4.2
Please also refer to 2.1 - General Safety
Instructions and 5.2 - Additional Safety Rules -
Cordless Drill/Driver before using the Drill Press.
Ensure the circular saw or jigsaw are NOT
installed onto the lid of the case before starting
to assemble the drill press.
Always use the lever provided to operate the drill
press pull down function.
Use the work clamp provided to hold the
workpiece firmly onto the table surface before
starting cutting. Support workpiece on the table
by thin wood before drilling.
Use only correct drill bits and/or accessories.
10.2
Drill Press - Specifications & Know Your Product
11.1
Drill Press - Additional Safety Rules
Voltage: 18V
No load speed: 350 RPM, 950 RPM (LIGHT)
Max Drilling Capacity:
Steel 1/2” (13 mm)
Wood 1 1/10” (28 mm)
Concrete 1/2” (13 mm)
Hammer Impact Frequency:
0-5,600, 0-20,000 min -1
Specifications
The maximum chuck capacity of your this Drill
Press is 10mm.
(13mm if you have purchased
the Hammer action drill version)
Never touch drill bit or any moving parts during
use.
Do not attempt to remove workpiece or any
other material when the chuck or cutting tool is
moving.
Never leave the drill press running unattended.
Turn power OFF by pressing the RED Button
and remove the POWERhandle from the dock.
Don't leave the drill press until it comes to a
complete stop.
11.2
Post
Product Lock
Drill Lever
Gear Selection
Height
Adjustment Lever
Work Surface
Operation Buttons
Drill chuck capacity:
Single Sleeve
½” (13 mm) keyless
Double Sleeve ⅜ ” (10 mm) keyless
Drill Press - Assembly 11.3
1. Remove the Post from its storage area, as
described in ‘Case Post Storage’ section 9. It is not
necessary to remove the lift out tool tray for the drill
press function, but when the drill press is fully
assembled it will become difficult to access the
inside of the case. Now push the post firmly down
into the hole on the top of the case with the green
hook facing outward and the head over the centre
of the work surface.
2. The post will snap into its highest setting whilst
the green lever is flush withe the work
surface. The Green lever can be lifted
from the rear at any time, this to allow
the post’s to move freely so the height
can be adjusted. Move the post roughly
to your required height and return the
green leaver flush with the work
surface. You may need to slide the post
up or down a little to find the next
locking position.
3. Slide the drill up firmly up into the
posts mating faces, until you hear a
‘click’. Push down on the top of the
drill to ensure it has latched in
correctly. The release
latches should be forward.
1
3
2
350 RPM, 1,250 RPM (HAMMER)