Maintenance, Environment, Storage
9.0
Lubrication
No Lubrication is necessary, the bearing area sealed.
After each: use, carefully clean the trimmer with a brush or rag.
Clear any debris from around the moving parts.
General inspection
Regularly check that all the fixing screws are present and tight. They may vibrate loose over
time.
Keep the tool's air vents unclogged and clean at all times.
Remove dust and dirt regularly.
Cleaning is best done with compressed air or a rag.
Never use caustic agents to clean plastic parts.
CAUTION
, Do not use cleaning agents to clean the plastic parts of the tool. A mild detergent
on a damp cloth is recommended. Water must never come into contact with the tool.
When the time comes to dispose of this product please consider the environment and take it
to a recognised recycling facility instead of disposing with general household waste.
The trimmer uses a Lithium Ion (Li-Ion) battery which must be disposed of properly.
Call your local council, civic amenity site, or recycling centre for information on the recycling
and disposal of electrical products and Lithium Ion (Li-Ion) batteries.
Storage
Store the tool, instruction manual and accessories in a secure, dry place. In this way you will
always have all the information and parts ready to hand.
Never Store the Trimmer With a Flat Battery.
The battery should ideally be stored between 10ºC and 24ºC (50ºF) and (75ºF).
WARNING
,
Switch
off
and
remove
the
battery
before
carrying
out
any
maintenance
on
the
tool
.
WARNING
,
The blade that cuts
the line is sharp.
FAQ
10.0
Where can I get more cutting line,
batteries and accessories?
www.cel-garden.com
or ask your retailer.
Why does the line break?
Usually because of hard objects or wearing. Try
to avoid these objects. When cutting thick grass
take small cuts as the outer diameter of the
rotating line will cut more efficiently than the
inside.
The line is not cutting cleanly, why?
Most likely the cutting line has worn out, extend
some new line or replace used line, newer line
has more weight and sharper edges. Debris may
have entered the moving parts near the cutting
area, clear with a brush. Ensure a charged
battery.
The trimmer wont start, what’s wrong?
a)Check the battery is charged and properly
fitted, also make sure the triggers are working
correctly and both are being squeezed at the
same time. b)Remove the battery and check for
debris, clean accordingly.
c)The Lithium Ion battery has a protection circuit
to prevent it from completely discharging. The
battery will provide constant power then stop
rather than slowing down. Recharge fully.
Why does my trimmer stop sometimes?
See c) above.
Do I need to fully discharge the battery
before recharging it?
No the Li-Ion system has no memory effect so
you can charge it at any time. The charge will be
retained in storage for much longer than older
battery technology.
Where should I keep my Line Trimmer ?
In a dry place at a stable temperature
What should I do if my Line Trimmer gets
wet?
Dry fully for several days in a warm but not hot
place before trying to charge or use
.
How can I get my Line Trimmer repaired if
it is damaged?
Contact your retailer.
Where do I find my serial number?
On the right hand side of the trimmer head.
Where can I get replacement parts,
advice or help?
Ask at your retailer or visit
www.cel-garden.com
How long is the warranty and what is
covered?
Please see inside cover
between
10ºC and 24ºC (50ºF and 75ºF)
.
