Cel-Fi PRO X may be ordered with or
without a cable. Any cable may be
used providing it satisfies the cable
specifications below.
HELPFUL HINTS:
• Find the desired location for the Cel-Fi Network Unit and Coverage Unit to determine
the cable route and length. If you are new to Cel-Fi Pro and Cel-Fi Pro X, visit us at
www.cel-fi.com
for more information.
• Route the cable between the Network and Coverage Units.
• Coil and secure any unused cable where convenient. Additional or unused cable length
will not affect system performance, as long as the cable loss specifications are met.
• Secure the cable at each end so no tension or movement exists at either cable end-
connector.
• Using the Cel-Fi PRO Mounting Brackets may help ensure that there is no Cel-Fi Unit
movement that might damage the cable or connectors.
•
Finger tighten
the end connectors to both Cel-Fi PRO X
connectors using the supplied wrench. Over-torqueing the
connector could damage the unit.
If the Network Unit and Coverage Units will
not link:
• First, inspect the cable connections to make
sure they are well seated.
• Next, make sure there is at least 1 meter of
separation between either Cel-Fi Unit and
any other transmitting device (cordless
handset or base, Wi-Fi router, etc.).
• Test that the Cel-Fi Units link properly when
in the same room (without the cable). If they
will not link please contact
Nextivity Support
for assistance at www.cel-fi.com/support.
• If the Cel-Fi links properly in the test
above, inspect the Cel-Fi PRO X and cable
connectors for looseness or damage, and
inspect the cable for damage. If damaged,
repair or replace the damaged cable.
Not all coverage bars are displayed:
• This is normal. When Cel-Fi PRO
X is used, the number of CU
bars does not relate to coverage
potential, which is most likely
maximized with Cel-Fi PRO X.
Any other Cel-Fi system problem:
• See your Cel-Fi Quick Start Guide
Troubleshooting Section, or contact
Nextivity Support for assistance at
www.cel-fi.com/support.
CABLE SPECIFICATIONS
• 50 ohm Impedance
• SMA Male connectors at each end
• Cable loss should be less than
40
dB @ 6GHz.
CABLE INSTALLATION
TROUBLESHOOTING
Copyright © 2017 by Nextivity, Inc, U.S. Patents pending. All rights reserved. The Nextivity and Cel-Fi logos are registered trademarks of Nex-
tivity Inc. All other trademarks or registered trademarks listed belong to their respective owners. Designed by Nextivity Inc in California.
guide_install-PROX-eng_17-1108
