8/27
4. Preparing the machine for use
4.1 Generally
Place the machine on a flat, firm surface. Lower the four support legs so that the machine stands stable.
The control panel can during transport have been placed under the machine to protect it from impact.
The control panel is mounted on the side of the machine before it is taking into use, using 4 screws.
Screw the adapter for the filter bag (item 9011-20519) onto the outlet pipe and hang the filter bag (item
9011-20517) on it. Put the bucket with paint/fluid underneath the filter bag. Remember to stir the fluid.
Place the suction and excess pressure hose (items 9011-20587 and 90-20585) in the bucket.
Connect the machine to the power source as prescribed.
The machine is attached to the power station following the local regulations. If it turns out to be
necessary changing the plug, the directions from the supplier must be followed. This job is only to be
done by a competent electrical specialist.
4.2 Emergency stop
Normally a person on each end operates the machine.
It is possible to operate with only 1 person. If that is the case, insert only max. 10 shingles, before
emptying the tray, which is installed at the machines end.
Activating the emergency stops, which are placed by the operator on both ends, can stop the machine.
When an emergency stop is activated the forward drive is stopped.
The pump continues pumping.
After activating the emergency stop, the machine can only be restarted by unlocking the emergency
stop and activating the start button again.
NB: Before starting the machine again be sure that the incident has come to an end, and that the reason
for activating the emergency stop is known.
4.3 Stop
During normal use the buttons ”Pump and ”Forward drive” put in stop position stops the machine.
When the machine is stopped, in order to be moved, repaired e.g. the main switch on the control panel
must be turned to position “0”. (Power is off.)
