Issue 4.0
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
5
3.2
To change from handset operation to speakerphone, press the
speakerphone push button and then hang up the handset. A normal
speakerphone conversation is then allowed.
3.3
To change from speakerphone to handset operation, pick up the handset
and then press the speakerphone button. Normal handset operation should
follow.
3.4
The phone need not be switched at all. The call may be made entirely
with the handset or entirely with the speakerphone.
3.5
If a call is placed to the phone, it may be answered in either mode and
switching between modes would be as stated above.
NOTE:
When switching between the two modes (speakerphone and
handset) be sure to activate one device before deactivating the
other to avoid an accidental hang up.
3.5
To end the phone call in handset mode, simply hang up the handset. To
end the phone call in speakerphone mode, press the speakerphone button.
When the telephone has actually been hung up, the red light will turn off.
4.0
RECOMMENDED TOOLS
Security Tool (CEECO P/N 301-064) sold separately.
Screw Drivers – Flat Blade and Phillips Head.
Wire Cutters/Strippers.
Mounting hardware and appropriate tools for installing mounting box.
5.0
INSTALLATION NOTES AND ASSEMBLY INSTRUCTIONS
5.1
Using a 301-064 security tool (sold separately) remove the six (6) security
screws.
5.2
Remove the telephone assembly from its mounting box and place it
carefully out of harms way.
NOTE:
Avoid contacting the internal parts of the telephone assembly
with other objects, as this may cause damage to the telephone.
Install the mounting box in the desired location (vertical surface).
5.3
Run the inside station wire through the mounting box and terminate the
wire on the RJ11C terminal block.
5.4
The use of gas tube or carbon station protectors is recommended. The
station ground should not exceed 50 ohms.
