ISSUE 4.0
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
8
3.10
When
programming is finished
, return the
mini-jumpers
to the
"OFF"
position.
Hang up the phone
by pressing the CALL button. The phone is
now
ready for Testing/Operation
.
4.0 TESTING/OPERATION
4.1
Connect the telephone to a working telephone line.
4.2
To make a call, press the CALL button located on the front of the phone.
When dial tone is received, the transmitter is muted and the phone waits
for numbers to be dialed. The LED will light RED at this time, and the
preprogrammed number(s) will dial out on the line.
4.3
The LED will flash red and green, while the call is ringing.
4.4
When the called party answers the LED will turn GREEN after a
maximum of four seconds, provided the ADA feature was activated (see
section 3.7 Digit 6). Otherwise, the LED will remain RED during off-
hook periods. A normal speakerphone conversation should be allowed.
4.5
When the call is complete, press the CALL button again to hang up. The
LED will go out and the call will be terminated.
4.6
If the user does not press the CALL button when he or she is done, the
phone will hang up after detecting a wink back from the far end, or when
the selected time-out period (see section 3.7 Digit 3) expires.
4.7
Place a call into the phone. If the phone was programmed to allow
incoming calls, answer the phone and the microphone should activate
within approximately three (3) seconds. A normal speakerphone
conversation should follow. If the phone was programmed not to allow
incoming calls, the microphone will not activate.
5.0 RECOMMENDED TOOLS AND TEST EQUIPMENT
DTMF Test Set
Volt/Ohm Meter
3/8" Nut Driver
5/16" Nut Driver
Flat Blade Screw Driver
Security Tool CEECO P/N 301-064
6.0 INSTALLATION NOTES AND ASSEMBLY INSTRUCTIONS