ISSUE 4.0
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
10
PROGRAMMING CONTINUED…
3.9
When programming is finished,
hang up
the telephone by pressing the
"CALL & HANGUP” button. Return the two plastic
mini-jumpers
to the
"OFF"
or outermost position, as depicted in the diagram on the last
page of this manual. The phone is now ready for use.
4.0 OPERATION
To make a call, press the "CALL" button located on the front of the phone and
wait for dial tone. The LED will light red at this time. When dial tone is received
the transmitter is muted and the phone waits for numbers to be dialed
.
The user
may utilize the keypad to dial numbers in accordance with any programmed call
restrictions or speed dial numbers. The LED (if activated in section 3.0) will flash
red and green during the ringing cycle.
When the call is answered, the LED will
turn green (after a maximum of four seconds), and a normal speakerphone
conversation is allowed.
After the call is complete, press the button again. The LED goes out and the call is
terminated. If user does not press the "CALL" button when he or she is finished
using the phone, then the phone will hang up after detecting dial tone or when the
telephone automatically disconnects as programmed.
If Digit 1 of Location #00 is "0" then call restrictions are in effect. The numbers
that may be dialed are restricted to the numbers entered into Location #70-#89. If
the number dialed is not in the Location #70-#89, then the phone gives three tones
and drops the line.
If Digit 1 of Location #00 is set to "1", then there are no restrictions and any
number may be dialed.
5.0 RECOMMENDED TOOLS AND TEST EQUIPMENT
Volt/Ohm Meter
5/16" Nut driver
3/8" Nut Driver
Security Tool, CEECO Part Number 301-037
Flat Blade Screw Driver
DTMF Test Set
