ISSUE 4.0
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
9
6.0 INSTALLATION NOTES AND ASSEMBLY INSTRUCTIONS
6.1
Using a 301-037security tool (sold separately), loosen and remove the
security screws.
6.2
The security tool is for a standard 5/32" button head screw generally used
on the framework of the phone booths.
6.3
Run the inside station wire into the housing enclosure and terminate on the
RJ11C terminal block inside
.
6.4
The use of a gas tube, or carbon station protector is recommended. The
station ground should not exceed 50 ohms.
6.5
Plug the modular line cord from the faceplate assembly into the RJ11C
terminal block.
6.6
Dress the line cable away from the security screws and seat the faceplate
into the housing enclosure
.
6.7
Secure the faceplate assembly by tightening the security screws
.
*****WARNING*****
A. Never install telephone wiring during a lightning storm.
B.
Never install telephone jacks in wet locations unless the jack
is specifically designed for wet locations.
C. Never touch uninsulated telephone wires or terminals unless
the telephone line has been disconnected at the network
interface.
D.
Use caution when installing or modifying telephone lines.
