ISSUE 4.0
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
6
The programming of the speed dial locations is significantly different than
in the past. Each location must now be accessed by entering #34 before
the actual location, and * at the end of the sequence. Numbers may be
programmed one after another by repeating the steps just previously
mentioned. The telephone does not have to be placed on hook after each
location is programmed.
For example: #34015551212*#340218005558989* will enter the
number 555-1212 into the #01 location and the number 1-800-
555-8989 into the #02 location.
2.8
An
individual number may be erased
or changed by just entering #34,
followed by the appropriate location (00-99), followed by the new number
to be dialed OR no number (erased), followed by *. Example #3402*
would erase the contents of speed dial location 2. Entering #3402 + a
number to be dialed, + *, would program that new number.
2.9
Locations 00 - 99 are the speed dialing memory locations. Log the
numbers programmed into Section 3.0 Programming Tables for future
reference.
2.10
When programming is
complete, hang up the phone
(“on-hook
condition).
2.11 REMOTE
PROGRAMMING
This telephone is equipped with the necessary electronics and software to allow
remote programming. If the telephone lines are set up to allow direct access to
the telephone, then the programmer does not need to physically be with the phone
to program it. To allow this, the
DIP switch
at position S2 of the printed circuit
board
must be set
with positions 1 & 3 “ON”, and position 2 “OFF”,
as follows
: