ISSUE 4.0
3.0 PROGRAMMING
3.1
Remove the backplate from the telephone and
connect the telephone
modular cord to a DTMF test set or a working telephone line.
3.2
Looking at the rear of the phone,
connect the programming keypad
to
the white connector, which is hanging freely inside the phone. This
connector attaches to seven different colored wires and has a similar end,
which is already connected to the Printed Circuit Board.
3.3
Locate the two plastic
mini-jumpers
on the corner of the Printed Circuit
Board and move them to the
"ON" position
, as depicted on the last page
of this manual. Lift the handset and wait for dial tone.
3.4
Utilizing the programming keypad,
enter
# 9 7
on the keypad. This
will
clear all
field programmable memory.
NOTE:
During programming it is essential to press the keys deliberately
and slowly. Missed or partial tones will result in improper programming.
3.5
If the phone must
automatically dial a number
, when the handset is
lifted,
enter # 1 9
on the programming keypad,
followed by the desired
number
of up to twenty-five (25) digits in length. Once programmed, this
number will always dial, when the handset is lifted.
EXAMPLE:
Entering #1918005551212 on the programming keypad will
cause the phone to automatically dial the number 1-800-555-1212, when
the handset is lifted.
•
Be sure to record your number in the Location #19 Table below for
future reference.
LOCATION #19 TABLE:
__ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __
3.6
If the phone must
automatically dial a second number,
when the handset
Is lifted,
enter # 2 0
on the programming keypad,
followed by the desired
number
of up to twenty-five (25) digits in length. In order for the phone
to dial the number stored in the #20 programming location, you must
select a “1” for Digit 1, under the #00 programming location (refer to next
section-3.7). You must also make selections for Digits 2 and 3
accordingly. Location #19
must
be used in order to use Location #20.
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
5