Cedima • Technical Documentation • Joint Cutter CF•1020 D • Issue date: 21/09/2021
71
Eliminating disruptions in operation
Operation
CAUTION
Danger of injury due to rotating diamond saw blade!
When the diamond saw blade dips into the surface to be cut, the machine can carry out
unforeseeable movements.
Always remain in the working area of the machine during operation, see the chapter
"Machine Overview" > "Working and danger areas" (page 46).
Never reach into rotating parts or under protective covers during operation!
Always make sure that there are no persons within the danger area of the machine dur-
ing operation!
Always exercise caution when dipping of the saw blade into the surface to be cut!
Always hold the machine firmly by the height-adjustable handle.
Carry out the following steps:
Using the
"
crank
handlE
for
cutting
dEpth
adjuStmEnt
"
, carefully lower the
"
cutting
Shaft
"
to the desired cutting depth, see the chapter "Set-Up" > "Moving cutting shaft"
!
Watch the cutting depth scale on the illustration of the cutting depth.
The diamond saw blade dips into the surface to be cut.
The cutting shaft has been lowered.
Carry out the following steps:
Carefully move the forward in the cutting direction
"
machinE
"
using the
"
hEight
-
adjuSta
-
blE
handlE
"
.
Cutting has been carried out.
That's it!
7.4 Eliminating disruptions in operation
Stop operation immediately if disruptions in operation occur. If the operator is not author-
ised or cannot eliminate the disruption, the superior must be informed. The table on trouble-
shooting is contained in the chapter "Maintenance, repairs and shut-down" > "Troubleshoot-
ing" (Page 84).
Lower cutting shaft
Carrying out cut-
ting
