GridScan/Pro SI
English
8
© CEDES | V 1.0
Important:
- Switch off main power to the door control unit and mark clearly that this system is out of service before
performing any work on the system.
- Mount the receiver edge into the guiding rail next to the door control unit.
Receiver and emitter must be
mounted at the same height.
Important for the blanking mode:
Mount the receiver edge into
the guiding rail next to the door
control unit (Figure 7).
In order to fulfill EN 12978:2009
the lower end of the edges has to
be at the level of the door closed
position.
Important for the static mode:
When the GridScan/Pro SI is statically
mounted (Figure 8) the door must
not interrupt the beams (no door
blanking).
Check the alignment of the edges.
The receiver must be mounted 180°
to the emitter.
Important:
Make sure the optical elements are
facing each other (Chapter 5.3).
Drill the holes for mounting at the
marked position (mounting holes of
the edge are Ø 4.3 mm).
Important:
Do not drill through the mounting
holes of the edges.
Mount the edge with screws from the
front side into the drill holes.
Mount the emitter edge opposite
the receiver edge. If the receiver
is mounted in the guiding rail, the
emitter should be mounted opposite
the receiver in the guiding rail.
Important:
Make sure the optical elements are
facing each other (Chapter 5.3).
Mark the mounting hole on the
mounting guide.
90°
1.1
2.
3.
For Tx repeat:
1.1 – 1.3
2
3
1.2
1.3
Ø 4.3 mm
