cecotec FAST&FURIOUS 4040 ABSOLUTE, Instruction Manual

Page: 16 / 19

FAST&FURIOUS 4040 ABSOLUTE FAST&FURIOUS 4040 ABSOLUTE 30 29
ENGLISH ENGLISH
the steam head and the cloth.
Note: If the garment steamer’s operating sound becomes louder and no steam is ejected, this
indicates there is no water in the tank. Please, check the water tank.
Release the steam button to stop the steam.
Tips
It is suggested to iron or steam clothes on its inner side.
Trousers may be ironed or steamed holding them by the ends.
The garment steamer does not eliminate stains.
Do not steam clothes while worn.
The garment steamer can be used almost on any type of fabric: Silk, jeans, cotton, polyester,
wool, etc.
Always check if the garment to be steamed has a label with instructions for ironing, and if it
has, follow the instructions.
When taking it for traveling, do not carry the unit base, only carry the main body for easier
storage.
After use
When you have finished using the device, keep power turned on and heat for about 15 seconds,
until there is no steam.
Press the power switch to turn the device off or disconnect the power cord from the power
supply.
Allow the iron to cool down completely. Be careful not to burn yourself! Remove the tank, open
the tank inlet cover and empty the remaining water in the tank.
Place it vertically on a flat surface and wait for the product to cool before storing it.
Fig. 2
1. ON/OFF
2.
Empty water tank warning
3. Low steam level
4.
High steam level
5 . CLEANING AND MAINTENANCE
Turn off, unplug the appliance from the power supply, empty the water tank (do it after each
use) and allow it to cool down completely.
Using distilled or de-mineralized water will reduce the need to clean your steamer and will
prolong its life. However, ordinary tap water may be used as well.
Additives such as cleaning agents, detergents, salt, perfumes and dyes should never be added
to the water tank.
Use a soft, damp cloth to clean the device’s surface after each use.
Do not use abrasive cleaners or scouring pads to clean the product.
If scale blocks the steam holes, use a toothpick to remove it.
If the appliance is not going to be used for a long time, pour out the water in the tank and store
the iron in a safe, cool place.
Mineral deposits cleaning
To prevent minerals from building up or reduce them, follow the below recommendations.
Carry out this process once every month if not using natural water.
Make sure the appliance is unplugged and cooled down.
Mix 50 % of descaling product and 50 % low-mineral or natural water.
Remove the water filling opening cover and pour the mixture into the water tank. Replace the
cover.
Allow it to take effect for 40 minutes and then empty the tank.
Wipe down the housing with a damp cloth.
Fill the tank with clean water, rinse and empty. Repeat this step until any odour disappears.
Assemble the unit back and use it normally.
This process only cleans the water tank.
Do not plug the device during this process.
6 . TROUBLESHOOTING
No light indicator turns on. Check main plug is inserted correctly.
Check the power supply.
Full screen flashing
and buzzing. *NTC short circuit or short circuit.
*NTC high and low temperature protection
procedure.
Contact the Technical Support Service of
Cecotec.
The steamer does not heat up. Check whether the switch is on and the device
is properly assembled.
No steam is generated. Make sure the water tank is correctly
assembled.
Check the water level in the tank.
Press the steam button harder.