cecotec CONGA ROCKSTAR, Instruction Manual

Page: 22 / 28

22 | CONGA ROCKSTAR 1200 ULTIMATE-ERGOFLEX
ENGELSK
- When assembling these 2 parts, make sure the handle and the brush are
facing the same direction.
Battery and handheld vacuum cleaner assembly
- Introduce the battery in the slot located in the handheld vacuum cleaner.
Once inserted, check that it is securely in position.
Fig. 3
- Following the below illustration, keep the vacuuming tube vertically, align
the tab on the vacuuming tube with the guides in the handheld vacuum
cleaner and introduce the tube.
Dust tank assembly
- To assemble the dust tank to the handheld vacuum cleaner, first separate
the handheld vacuum cleaner from the vacuuming tube.
- Then, press the vacuuming tube release button with one hand and, holding
from the handle with the other one, turn the dust tank anticlockwise to
the unlock position indicated on the dust tank edge.
- To disassemble the dust tank, turn it clockwise until it reaches the unlock
position.
Fig. 4
Suction base, vacuuming tube and handheld vacuum cleaner installation
To complete the full installation of the device, hold the vacuuming tube with
the suction base assembled upright and introduce the tube in the handheld
vacuum cleaner as shown on the illustration.
Fig. 5
4. OPERATION
Handheld vacuum cleaner
- Once the handheld vacuum cleaner has been disassembled from the
vacuuming:
- Press the On/off button to turn the device on.
- Press the power push button to select the desired power level.
- It will automatically operate in Eco mode. The power level can be adjusted
at any moment by pressing this button.
- Press once to switch to Daily mode.
- Press again to operate it at Turbo mode.
- Press the power button to switch the device off.
Fig. 6