CONGA ROCKSTAR 1500 ULTIMATE-ERGOFLEX
|
27
ENGLESK
and remove the cover of one of the ends of the brush.
- Take one end of the brush out as shown on the image.
- It is important to clear and clean all the residues left in the brush’s rotary
axis.
- After washing and drying all the parts, assemble it back in order to use the
brush again.
Fig. 21
How to remove the battery
Press the battery release button and take the battery out as shown on the
image. Store the battery in a plastic bag and leave it in a dry place.
Fig. 22
Storing the device
- If the robot is not going to be used for a long time, remove the battery from
the product and store it in a dry and safe place.
- Maintenance indicator
- The full tank icon or the obstructed filter icon will be displayed if the device
has not been properly and frequently maintained.
Fig. 23
6. TROUBLESHOOTING
Problem
Possible cause
Solution
The motor does
not operate
The battery does not work any
longer.
The metallic tubes, floor brushes,
batteries or the device itself are not
properly assembled.
Charge the vacuum cleaner.
Make sure all parts of the device
are correctly assembled.
The suction
power has been
reduced and the
appliance makes
a lot of noise.
Fig. 23
The dust tank is full.
The filter has too much dust.
The electric rotary brush inlet is
obstructed, or the brush is blocked.
Clean dust.
Clean or replace the filter.
Clean the dust inside the electric
rotary brush.
Insufficient ope
-
rating time
after charge.
Insufficient charge time.
The battery is old.
Fully charge the battery fol
-
lowing the instructions in this
manual.
Batteries are easily recycled. Go
to the closest maintenance point
and buy new batteries.
