cecotec CONGA 999 VITAL X, Instruction Manual, Page: 36 / 128

36
ENGLISH
Scrubbing mode
-
Attach the mop cloth to the mixed tank and fill the tank with water.
-
Install the mixed tank in the robot and select the mode.
-
Use the remote control to select the desired scrubbing power level: high, medium or low.
-
Once you have selected the desired scrubbing level from the remote control, the robot will
start the All in One function to vacuum, scrub and sweep at once thanks to its mixed tank.
Fig. 26
Warning
-
If you wish to sweep the floor, skip the water-filling step.
-
If the robot has the mixed tank installed, when it leaves the charging base, it will turn
around itself to soak the mop.
-
To ensure perfect scrubbing from the start, it is suggested to dampen the mop cloth evenly
with water before use.
-
It is recommended to be present when the robot is scrubbing.
-
Do not leave the wet mop attached when the robot is in the charging base.
Spiral mode
-
Select this mode for the robot to carry out an intensive cleaning of a specific spot. The robot
will start cleaning in a specific spot and will move outwards performing spiral movements
(1 metre). Then, it will return to the start point in spiral movements again.
-
Once it has finished and returns to the start point, the robot will start cleaning in Auto
mode until it runs out of battery.
-
Before operating the robot with the Spiral cleaning mode, place it on the spot to be cleaned.
-
Press the spot cleaning button on the remote control. Fig. 27
Edge mode
-
When this mode is selected, the robot will clean along walls and around furniture (e.g.
table or chair legs).
-
Press the edge cleaning button on the remote control. Fig. 28
Room mode
-
The robot will carry out a 30-minute cleaning cycle when this mode is selected.
-
Press the Room mode button on the remote control. Fig. 29
-
To ensure an efficient cleaning of the room where the robot is operating, close the door.
Back home mode
Press the Back home button on the robot or on the remote control (with a house icon) in order
to send the robot to the charging base. The robot will continue sweeping until it gets to the
charging base.
Manual mode
Press the arrow buttons on the remote control to use the robot manually.