CONGA ROCKSTAR 2000 ULTIMATE-ERGOWET CONNECTED
|
29
ENGLESK
shown on the following figure.
Note: If the vacuum cleaner is not going to be used for a long period of time,
make sure to remove the water tank and to empty the remaining water. Do
not expose it to direct sunlight or to damp environments.
Removing the mop cloth
To remove the mop cloth, just hold it with your hand and pull form it to
detach it from the water tank.
Cleaning and maintenance
Water tank cleaning
- To clean the water tank, fill it with clean water, shake it, and empty it.
- The mop is washable; therefore, it is suggested to wash it after every use.
- Replace the cloth after 20-30 uses, depending on the use.
- When the mop cloth is used for a long time, it is possible that the water
output is affected. This can be avoided by cleaning both cloth and water
tank regularly.
7. TROUBLESHOOTING
Problem
Possible cause
Solution
The motor does
not operate
The battery does not work any
longer.
The metallic tubes, floor brushes,
batteries or the device itself are not
properly assembled.
Charge the vacuum cleaner.
Make sure all parts of the device
are correctly assembled.
The suction
power has been
reduced and the
appliance makes
a lot of noise.
Fig. 24
The dust tank is full.
The filter has too much dust.
The electric rotary brush inlet is
obstructed, or the brush is blocked.
Clean dust.
Clean or replace the filter.
Clean the dust inside the electric
rotary brush.
Insufficient ope
-
rating time
after charge.
Insufficient charge time.
The battery is old.
Fully charge the battery fol
-
lowing the instructions in this
manual.
Batteries are easily recycled. Go
to the closest maintenance point
and buy new batteries.
8. ERROR CODES
Code
Problem
Cause
E1
The device turns off and does not
charge
Short-circuit
