30
|
CONGA 4690
ENGELSK
clip is properly fastened.
Only for Wet & dry tank installation:
Attach the mop to the bottom part of the mop bracket with the Velcro.
Manually press the clips on both sides of the Wet & dry tank and push it into
its correct position.
You will hear a click when it is properly fixed.
Recommendations:
Do not use the scrubbing function while the robot is unattended.
Remove the Wet & dry tank when the robot is charging or not in use.
If there are carpets in the house, set Restricted Areas to avoid the robot
from passing over them.
Add some drops of cleaning agent (not corrosive) if considered necessary.
To remove the mop bracket, press the release button and pull from it out
-
wards.
Warnings:
Using cleaning agents in excess might block water outlets.
In order to achieve perfect scrubbing, it is suggested to moisten the mop
before using it.
First cleaning
Once the robot and the charging base are completely installed, follow these
steps before scheduling the first cleaning cycle.
First of all, the robot must be fully charged. It is suggested to allow the ro
-
bot to charge overnight. When it is fully charged, it may carry out the first
cleaning cycle and save the first map. To do so, activate Auto cleaning mode
and Eco power level. It is very important to follow these indications for the
robot to recognize each and every corner in the house and to create a com
-
plete map.
If the house where the robot is going to be used is too big and the robot runs
out of battery, do not worry. The robot features TotalSurface 2.0 technology,
so when it returns to the charging base, it saves the full map and those that
have not been completed. Once it is charged again, it resumes the cleaning
cycle from the point it has stopped until it maps the whole surface.
The robot keeps on mapping constantly, therefore it adapts independently
to each house’s features and continuously improves previous maps.
4. OPERATION
Once the robot’s light indicator changes from oscillating orange to steady
