cecotec 05467, Instruction Manual

Page: 14 / 32

ENGLISH ENGLISH
26 27 CONGA ROCKSTAR 500 ULTIMATE ERGOWET CONGA ROCKSTAR 500 ULTIMATE ERGOWET
LONG BRUSH
This accessory is assembled to the handheld vacuum cleaner and can be used to clean any
type of surface.
WALL BRACKET
This product includes a wall bracket that allows hanging the vacuum cleaner from
the wall. The same bracket has different accessory holders that allow storing
accessories while not in use.
It can be assembled with screws (included with the product), or with an adhesive
(included with the product).
When using the adhesive, make sure to use it on a clear flat surface. Also make sure
that the suction base rests on the floor when hang to avoid the wall bracket from
falling.
CHARGING
The device can be charged in 2 different ways. It can be charged directly through the handheld
vacuum cleaner or the battery can be removed and charged separately.
It is important to charge it when the battery is low. While
charging, the battery indicator will turn on red, and it will turn
green when battery is fully charged again.
Disconnect it from the power adapter when the battery indicator
is lit up in green.
84,5 cm
6. CLEANING AND MAINTENANCE
• Do not use abrasive scouring pads, powders or cleaners to clean the product.
• Use a soft, dampened and clean cloth to clean the product’s outer housing.
• Do not let water enter into the vacuum cleaner.
• Keep the appliance in a cool, dry place and out of reach from children.
• Do not immerse the device in water and do not clean any of its parts in the dishwasher.
DUST TANK
To empty the dust tank, first disassemble the handheld vacuum cleaner from the rest of the
unit. Use the tab on the dust tank to open its cover and empty it. If necessary, shake it gently
to remove all the dust.
To clean it, press the dust tank release button and turn the dust tank
anticlockwise to the unlock position to remove it. Use water to rinse it, or
soap if necessary to remove dust.
Recommendation:
It is suggested to clean the dust tank after each use.
FILTERS
It is suggested to clean the filters regularly to ensure maximum efficiency. They can be cleaned
with warm water. Dry them thoroughly before installing them back in the device.
To take filters out:
1. Open the dust tank following the instructions on the before section.
2. Turn the metallic filter anticlockwise and remove it.