980 CONNECTED
47
46
ENGLISH
ENGLISH
Pink light
flashing
Power adapter is not connected or vacuum is not enough. If the cord is
unplugged and the product starts beeping, remove the product from the
window or plug it again to a power supply.
5. TROUBLESHOOTING
Ref. N.º
Problem
Cause
Solution
1
If the blue light
flashes, the robot
is checking that
conditions are suitable
for operating. If this
process takes longer
than 20 seconds, it
can be due to any of
these causes:
Mops are not installed
correctly
Remove the cleaning mop
and install it again to
make it flat.
Free-fall sensors error
Check if the free fall
sensor has any foreign
material that stops it
from working properly.
The glass surface is too
dirty.
Clean the are firstly
before sticking the
product to the window.
2
Red light flashes and
beeps
Power adapter is not
connected.
Connect to the power
supply first, and press
Start to make the product
work again.
In case of power cut, use
remote control to direct
the product to the place
where safely reach it and
remove it.
There is some risk when
using remote control
under power cut. Please
make sure that highest
safety precautions are
taken.
Vacuum power is not
enough during operation.
Use the remote controller
to take the robot back to
safe position.
There is some risk when
using remote control
under power cut. Please
make sure that highest
safety precautions are
taken.
Free-fall sensor error while
operating.
Check if there is any dust
in the free-fall sensors,
and clean it. If this does
not work, please contact
Cecotec’s customer
service.
