cecotec 05037, Instruction Manual

Page: 22 / 27

ENGLISH
22
FORCETITANIUM 520
2. PARTS AND COMPONENTS
A
J
I
B
C
E
F
D
G
H
K
A. Steam selector
B. Steam burst button
C. Spray button
D. Temperature indicator light
E. 360º swivelling cord
F. Temperature control dial
G. Water tank
H. Titanium Slide
I. Spraying mouth
J. Water tank cap
K. Autoclean button
3. BEFORE USE
· Remove all packaging elements.
· Inspect all parts of the appliance for visual damage. Unwind the power cord completely and
inspect it for damage. Do not use the appliance if it or its cord have been damaged or are not
working properly. In case of damage, contact the of
� cial Technical Support Service of Cecotec
for advise, repairs, or returns.
· Make sure you have read and understood all instructions and warnings in this instruction
manual. Pay particular attention to the safety instructions on previous pages.
· Place the appliance on an even, heat-resistant surface. Do not place the appliance near heat
sources, places with high humidity levels, or combustible materials.
· Plug the appliance into an appropriate wall outlet. The plug must be accessible so that, in case
of an emergency, it can be easily unplugged.
NOTE: you may notice a slight burning smell or smoke when using the appliance for the
� rst time, caused by the excess of lubricants from the manufacturing process. Ensure good
ventilation and let the appliance work until no odour or smoke can be noticed.
How t��ll with water:
Make sure the iron is turned off and unplugged from the mains supply before following the
instructions below:
1. Turn the steam dial to position ‘0’ befor
�� lling the tank with water.
2. Open the cap of the tank and � ll it up to the ‘MAX’ mark on the tank. The water level can be
seen through the transparent side of the tank when the iron is placed upright.
3. Pour out the remaining water after use.
Note: tap water can be used in this iron. Do not use water additives or substitute water, such
as linen or scented water in the steam iron. They can stain fabrics or damage the iron. Do not
exceed the ‘MAX’ mark on the tank.