56
ENGLISH
3. PRODUCT INSTALLATION
- Place the device on a flat, stable and dry surface. Make sure the product does not stand on
the power cord. Fig. 3.
- Avoid direct sunlight and ensure sufficient ventilation. Fig. 4.
- Remove the cardboard box and Styrofoam packing.
- Lift the washing machine and remove the base packing. Make sure the small triangle foam
is removed with the bottom one together. If not, lay the unit down on one of the sides, then
remove the small foam from the unit bottom manually. Fig. 5.
- Remove the tape securing the power supply cord and drain hose.
- Remove the water supply hose from the drum.
Removing the transport bolts
- The transport bolts must be removed from the backside of the device before installing the
washing machine.
- The transport bolts will be necessary again when moving the product, so make sure they
are kept in a safe place.
In order to remove the bolts: Fig. 6.
1.
Loosen the 4 bolts with a spanner and then remove them.
2. Cover the holes with the transport hole plugs in the box.
3. Keep the transport bolts properly for future use.
Levelling the washing machine
Warning
The lock nuts on all four feet must be screwed tightly against the housing.
1.
Check if the legs are closely attached to the cabinet. If not, please turn them to their
original position and tighten the nuts.
2. Loosen the lock nuts to turn the feet until they are in contact with the floor.
3. Adjust the feet and tighten the washers with a spanner. Make sure the machine is steady.
Fig. 7.
Water supply hose connection
Warning
Do not kink, crush, modify or repair the water supply hose.
For the models equipped with a hot valve, connect it to a hot water tap with the hot water
supply hose. Energy consumption will decrease automatically for some programmes. (Only for
some models).
Connect the water supply hose following one of the 2 methods:
