2
Cecilware
®
Electric Cheesemelter
Important Safety Information
This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages
that follow this symbol to avoid possible injury or death.
WARNING
• Do not deform power cord.
• Follow national and local electrical codes.
• Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other
appliance.
• Use only on a dedicated circuit load that is properly protected and capable of the rated load. Do not use
extension cords, as this could result in electrical shock, overheating, and fire.
• Risk of electrical shock. Disconnect power before servicing or cleaning unit. Contact Grindmaster-Cecilware
Technical Service for service assistance.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agents or similarly
qualified persons in order to avoid a hazard.
FAILURE TO COMPLY TO THE ABOVE RISKS PERSONAL INJURY, SHOCK HAZARD, FIRE, OR DAMAGE TO
EQUIPMENT.
CAUTION
• Read and understand the operating instructions in this manual thoroughly. Only allow properly trained
persons to operate this machine.
• Stay alert at all times during operation.
• Operate with care. Surfaces will get very hot and may cause serious burns.
• Keep operating area clean.
For your safety and the safety of others, read all warnings and the operator’s manual before installing or using
the product.
DANGER:
This term warns the user of imminent hazard that will result in serious injury or death.
WARNING:
This term refers to a potential hazard or unsafe practice, which could result in serious injury or
death.
CAUTION:
This term refers to a potential hazard or unsafe practice, which could result in minor or moderate
injury.
NOTICE:
This term refers to information that needs special attention or must be fully understood.
Unpacking
Carefully lift unit out of shipping container, and inspect
immediately for shipping damage. Your Cheesemelter
was shipped in a carton designed to give it maximum
protection. It was thoroughly inspected before leaving
the factory. File any claims for shipping damage or
irregularities directly with the carrier.
Installation
Mechanical Installation
Counter location:
Select a suitable location for your
cheesemelter and adjust the leveling legs on the
bottom of the unit to level it and prevent rocking.
Height may be adjusted by turning the feet up or down
as desired.
Pass-thru location:
Remove the outer and inner back
panels and adjust the leveling legs.
Wall mounted:
Remove the outer back panel and
mount the wall brackets to the back of the unit using
the same screws. Refer to diagram on page 4. Position
the Cheesemelter on the wall and mark the four holes
through the mounting brackets on the wall. Use 5/16”
diameter toggle bolts 2" long or an equivalent fastener
to mount the unit to the wall.
Safety Information
NOTICE
