18
– Flexa 200 - 400/400 – User Manual – v1.0
T4S/CATENA start-up
5. T4S/CATENA start-up
If you have installed the T4S and CATENA by yourself, make sure to respect the connections as indicated in the
schematic.
If you have ordered the complete solution with cabinet and module from CE+T Power, both controllers are installed,
wired, tested and preconfigured according to the system.
5.1 Applying start-up power
NOTE: The controller will perform a short self-test as it boots up. Alarm alerts are normal.
•
Initiate the start-up routine by applying power to the T4S (close protection breaker powering the controller).
•
Use the touchscreen or a laptop to connect to the system.
NB: if you are connecting with your laptop, default IP address of user interface is http://192.168.0.2
There are two access levels:
•
Basic: after version 3.1, basic access does not require password. Before that, default password is
pass123.
•
Expert: default password is
pass456 but it’s strongly advised to users to change that password.
In case of lost password, please refer to FAQ at page 68
•
Check and adjust alarms and control levels in the controller sub-menus.
•
Check and adjust battery settings in the battery sub-menus; e.g. float, equalize voltage, etc.
•
If on touchscreen, check the communications settings for remote access as needed.
NOTE: System modification and setting may result in alarm event. Make sure you are applying modification carefully.
Summary of Contents for FLEXA 200 400/400
Page 17: ...17 Flexa 200 400 400 User Manual v1 0 Hardware setup Page 2...
Page 69: ......
