CE CLEVELAND CE-2500-HVE, Operation Manual

Page: 11 / 33

CE-2500-HVE Band Sealer
Page 10
6.3. Sealing Belt Adjustment / Replacement
6.3.1. Remove the safety cover, after the heating blocks cool, turn stopping flakes on both upper
heating block and upper cooling block by 90° to lift both, then loosen the springs on both
embossing roller and pinch roller, meanwhile, remove the guiding belt, to prepare it for
removing sealing belts. (see Diagram 6.2)
6.3.2. Move the driven wheel seat (adjusting block) towards heating block and remove the
sealing belt.
6.3.3. Replace with a new sealing belt and install the guiding belt back.
6.3.4. Put the driven wheel, heating/cooling blocks, and pinch roller to the original position.
6.3.5. Connect to the power supply to test the machine. If irregular sealing appears on the belt,
make adjustment by adjusting screws on the driven wheel seat (adjusting block)( see
Diagram 6.3).
6.3.6. Install the safety cover. When the temperature reaches the set temperature, the machine
is ready.
Diagram 6.2
1 101347 Bolt
2 101348 Withdraw Stopping Flake
3 101345 Tightening Bolt
4 101345 Tightening Bolt
1
1
1
1
2
2
3
3
4
4