Fitting Instructions
1. Hold the assembled product against the wall in the
desired location and adjust for level using a spirit level.
Mark the edges of the plastic bracket(s) then remove the
product from the wall.
2. Using the hex head key supplied, loosen the grub
screw(s) on the underside of the metal wall bracket pillar
and remove the plastic bracket(s).
3. Hold the plastic bracket(s) in their marked positions on
the wall and mark a screw position through the centre of
each hole. Check the marks are vertical using a spirit
level.
4. Using a 6mm masonry drill, drill the holes in the marked
positions to a depth of 50mm. If drilling through tiles,
please pre-drill using a ceramic drill bit.
5. Insert the wall plugs to the surface of the wall. If fitting to a tiled surface, the wall plugs should
be inserted below the surface of the tile to avoid cracking.
6. Insert the screw(s) through the wall fixing bracket(s) and screw into the wall plugs. Fit the
product over the plastic bracket(s) and tighten the grub screw(s) ensuring that the product is
level.
Product Care
To retain the best quality finish, clean product regularly with a soft cloth and mild detergents. Do
not use abrasive or chemical cleaners, as these will damage the product.
Do not place hot objects onto the surface of the glass shelf.
Do not position glass components in close contact with a heat source.
For details of the other items in the Cdx range please visit our website: www.cdxcollection.co.uk
Croydex Limited, Central Way, Andover, Hants, SP10 5AW, UK.
REVISION 3
APRIL 2006
