4] MOUNTING
2] NOTES AND RECOMMENDATIONS
3] OPERATE
1] PRESENTATION DU PRODUIT
IP55
-20°C to 80°C
CE Certification
Carrier frequency: 433,92 MHz,
Sound feedback,
Modulation: FM/FSK (Ref: SENSRAD/FTK2641F1)
or AM (Ref: FTK2641E1),
Frequency deviation: ±30 KHz,
N° channels: 1,
E.r.p. 1 mW,
Operating voltage: battery CR123A - 3 Vdc,
Current consumption:
- 12-15 μA stand-by,
- 40mA (SENSRAD/FTK2641F1),
- 20mA (FTK2641E1)
Battery life: 12 months,
Security protocol: Keeloq
®
Hopping Code,
Code combinations: 2exp64,
Range in open space: 150m,
Weight: 93gr.
WEEE & RoHS
25
60
90
The appliance uses a lithium battery type CR123A.
Insert the new battery on the battery location,
respecting the right polarity. The removal and the
disposal of the battery must have effected before
the elimination of the appliance and according to the
current Regulations.
Attention:
Danger of explosion if the battery is not
replaced in the correct way! Replace only with an
equal or equivalent type.
The Button operates when you skim over the
external surface with the hand. The sensitivity of
the detector can change according to the fixing
surface type: metallic surfaces increase the sensitivity
but can reduce the range of the radio transmission.
Approach the cover or touch it until the buzzer
sounds.The RF transmissions lasts all time the
buzzer sounds. Normally it’s necessary to skim over the
cover with the hand and not only with a single finger.
1
Locate the best position for the
installation, avoiding metallic surfaces
that could decrease the RF transmission.
2
Using the box bottom as a template
mark the position of the 4 mounting
holes.
3
Drill the mounting holes and insert
the plugs.
4
Assemble base and seal together,
install to mounting surface using
4 screws.
5
Install the module to base and secure
with the screws.
The Keyfree transmitter is a special radio transmitter operating at 433,92 MHz in FM/FSK
modulation. It’s mainly composed by a capacitive touch sensitive circuit and by a radio transmitter.
It can be used to operate gates or garage doors or any device with the corresponding compatible
433 MHz receiver.The security protocol is a rolling code type. Each product is already factory
programmed with a different security code.
TCB eco-syn
M3-15 Screw
Front box
housing
Wood screw
3.5x32
Battery
CR123A
Back box
housing
Joint
Anchor
S5
The product fully complies to the requirements
of the European Directives 73/23/CEE, 89/336/CEE, 99/05/CE.
EN
SENSRAD/FTK2641F1 - FTK2641E1
Keyfree transmitter
INSTALLATION MANUAL
2
cdvigroup.com