Fabricant de Contrôle d’Accès depuis 1985 Manufacturing Access Control since 1985
The installer’s choice
4
Layout & Wiring
GFA transmitters
The receiver allocation is very important for the best operation of the
system. Place the receiver far from interference sources such as big
magnetic fields or radio emissions. The installation and the positioning
of the antenna is very important as well. Before installing the antenna
it’s advisable to make some tests on the site.
The distance between 2 receiver must be at least 1,5m.
The appliance full comply with the requirements of the following
European Directives : 2006/95/CE, 2004/108/CE, 99/05/CE and the
Standard EN 60335-1.
5
Compatible transmitters
6
Warnings
7
Display Legend
There are 2 methods available:
1) Using P1 and P2 throughout the menu
2) Remote from the receiver, using a transmitter already in the receivers memory
(Mode PLUS ).
P1 : enter the menu ( 4 sec.)
or
confirm the choice
P2 : navigate
the menu
8
Programming / Navigation menu
Button activated
TX Serial number
Relay activated
The factory value for the timing is 1
sec. Use P1 to scroll the digits and P2
to confirm
Relay 1 : Pulse
Relay 1 : Step
Relay 2 : Timed
Menu
Timed
Add
: Add transmitters s/n
Delete TX
: Delete a single transmitter, the button of a transmitter, a transmitter
from a list , all transmitters Reset to factory default
Info relays
: Display relays operating mode, the number of Tx memorized, the of
Transmitters, the SW release.
Config relay 1 or 2
Set relay operating mode ( pulse , step, timed )
Set delay time of relay
Backup to
: data backup to an external memory
Restore from
: data restore from an external memory
Plus ON
: Enable remote transmitter memorization
Plus Limited
: Enable remote transmitter memorization only using a TX «ma-
ster» ( see chapter 12 )
Plus OFF
: disable remote transmitter memorization
Connector for
backup memory
Backlit
LCD Display
Buzzer
ERONE
XPL500
www.erone.com - www.cdvigroup.com
Fig. 5