CDVI GALEO BT, Manual, Page: 5 / 40

EN EN
GALEO BT
Keypad GALEO Bluetooth
5
cdvigroup.com
A. First use after reset
1. Power up the system
On the remote electronics:
- Green LED lights on
- Then the Red LED lights on
- Then the Red and Green LED flash
On the keypad:
- 1 beep is emitted
- The keypad lights on and flashes
2. Enter a new code twice for the master code
(only 5 terms).
The 12345 code is forbidden in master code.
- The keypad stop flashing
- After the first entry of the master code, the
keypad flashes 1 time
- Enter the second entry of the master code
- If both entry of the master code are the same, 2
beeps are emitted.
Otherwise, wait until the keypad flashes again to
enter the new master code twice
(about 10 seconds)
- Entry in programming mode
3. Configure the system with the
programming chart on the next page.
- Press B to exit from programming mode.
B. Reset memory
1. Cut off the power and put the jumper on
P1.
- Refer to page 4 for the jumper P1 on the remote
electronics
2. Put the power back :
On the remote electronics:
- Red LED lights on during reset
- After the reset, Red and Green LEDs still flashing
while waiting new master code
On the Keypad:
- 6 short beeps are emitted during reset and at the
end 1 long beep is emitted
- The keypad still flashing while waiting new master
code
3. Pull out the jumper on P1
- Master code and user codes are cleared and set
to default value
4. Start again from part A
C. Reset master code
On stand-by operating mode, put a jumper on
P1. Wait until the keypad flashes to enter new
master code.
On the remote electronics:
- Red LED lights on during the reset of the master
code
- Then Green LED lights on
On the keypad:
- 3 short beeps are emitting during the reset of the
master code and after that 1 long beep is emitted
- The keypad flashes while waiting the entry of a
new master code
D. Changing the code by user
To authorize a user to modify its own user
code, put a jumper on P2 (to disable the
feature, remove the jumper)
1. Enter the current user code
- The relay is activated and a beep is emitted
2. Enter the 2 digits sub master code
- Relay 1, default sub master code: A and B
- Relay 2, default sub master code: 1 and 3
- Relay 3, default sub master code: 4 and 6
- A beep is emitted to authorize the modification
3. Enter the new user code
- 2 beeps are emitted to confirm the new code
4. Check the new user code to be sure of the
modification