3.
Set the time to the desired setting, then press and release the START/STOP button to
restart the count-down.
USING THE COUNT-DOWN MEMORY FUNCTION:
For repeat timing tasks, you can save a count-down value in memory and then use it to quickly
program the timer. The memory holds one value.
1.
Press and release the MODE button to select the TIMER
6
mode. Then enter the desired
count value using the HR, MIN and SEC buttons.
2.
Press and release the MEM button. The message “REC” appears on the display to indicate
that the count value has been recorded in memory. Press and release the START/STOP
button to start the count-down in the normal manner.
3.
Now, whenever you want to reset the timer to the saved count value, use the MEM button
instead of the HR, MIN and SEC buttons.
Clearing a Count Value from Memory:
1.
If a count-down is active, stop it using the START/STOP button.
2.
Clear the timer by pressing the HR and MIN buttons simultaneously.
3.
Press the START/STOP button and the MEM button simultaneously, then release them.
The message “CLR” appears on the display to indicate that the value has been cleared from
memory. You can now save another value.
USING THE NAP TIMER
The NAP TIMER is another count-down timer that features a quick program mode. You can set
the NAP TIMER count-down value in 15-minute increments with the push of a button.
1.
Press and release the MODE button until the NAP TIMER mode appears on the display.
2.
Press the HR, MIN or SEC button to program the timer in 15-minute increments. (Pressing
any of these buttons increases the count-down value by 15 minutes).
3.
Press and release the START/STOP button to start the count down. To stop the count
down and reset the timer, simply press and release the START/STOP button again. (The
NAP TIMER resets to zero automatically when you press START/STOP.)
5 Year Limited Warranty
: Any instrument that proves to be defective in material or
workmanship within five years of original purchase will be repaired or replaced without charge
upon receipt of the unit prepaid at the address listed below. This warranty does not cover damage
in shipment or failure caused by tampering, obvious carelessness or abuse.
Component Design
Northwest, Inc.
P.O. BOX 10947
Portland, OR 97296
www.cdnw.com
