4
1
>
>
3
1
Preparation
Preparation
Initial Use
Initial Use
Removing & Replacing Freezer Door Handle
Get 2 fasteners out of the accessory bag and place them in 2 reserved
holes in the freezer door. Install a handle by attaching the reinforcing
plate to the fasteners and then pushing the handle into its
place. To
remove the handle, push it
to the right.
Fastener
Reinforcing
plate
Installing wine shelf
Open the door of refrigerator compartment. Take out the food shelf at the
upper left corner. Place the glass shelf downward on a table. Then take
out the wine shelf from the delicatessen drawer at the bottom. Hold the
wine shelf at both ends, attach it to the food shelf (as (1) shown below)
and then push it in place (as (3) shown below).
Connect the appliance to the power supply.
The appliance has a backup memory and the settings before
a power interruption will be stored.
(See Backup Memory section on Page 18 for details)
Operation Modes
NOTE
NOTE
Once the AI mode is selected, there is no need to make any
adjustment within a prescribed range of temperature, notwithstand-
ing the changes in ambient temperature.
When the temperature setting is adjusted, it takes some time to reach the
desired inner temperature. The period will be longer or shorter, depending on
the ambient temperature, amount of food and how often the door is opened.
You can select one of the following operation modes.
(1) AI: Unless otherwise required, it is recommended that the
AI mode is used. Tap the AI button and the indicator will
illuminate. The appliance will start an automatic operation.
(See the AI Mode section on Page 15)
(2) Manual: Alternatively, you can adjust the inner
temperature by means of the temperature control button.
(See the Temperature Setting & Regulation section on
Page 17)
Loading the refrigerator
The inner compartment will be cold enough and ready for
food storage after a couple of hours of non-load operation.
