CDA HVC70, Manual For Installation, Use And Maintenance, Page: 21 / 24

CONNECTING THE FEEDER CABLE
To connect the feeder cable to the hob it is necessary to carry out the following opera-
tions:
• Unscrew the screw A of the terminal board at the bottom of the hob (fig. 4.4).
• Unlock the 2 clips B and open the cover C.
• Unscrew the screw D and open completely the cable clamp E (figs. 4.6 - 4.7 - 4.8).
• Position the U bolts F onto terminal board G (figs. 4.6 - 4.7 - 4.8) according to the
diagrams in fig. 4.5.
• Connect the phase and earth wires to terminal board G according to the diagrams in
fig. 4.5.
• Strain the feeder cable and block it with cable clamp E (by screwing screw D).
• Close the cover C of the terminal board G and block it with the screw A.
FEEDER CABLE SECTION
“Type H05VV-F or H05V2V2-F or H05RR-F”
For 60 cm and 80 cm models:
220-240 V
~
3 x 2.5 mm 2 (**)
380-415 V 3N
~
5 x 1.5 mm
2
(**)
380-415 V 2N
~
4 x 2.5 mm
2
(**)
For 90 cm models:
220-240 V
~
3 x 4 mm
2
(**)
380-415 V 2N
~
4 x 2,5 mm
2
(**)
380-415 V 3N
~
5 x 2.5 mm 2 (**)
21
A
B
C
B
Fig. 4.4
(**) Connection with wall box connection.
– Diversity factor applied
– A diversity factor may be applied to
the total loading of the appliance only
by a suitably qualified person.