16
IMPORTANT - PLEASE NOTE:
In the event of any breakage, crack
or cracking – even minimal – of the vitroceramic glass, immediately
disconnect your appliance to prevent a risk of electric shock and
contact CDA Customer Care.
In use
You observe that
Possible Causes
What should you do?
The hob has stopped operating.
The hob beeps at approximately
ten second intervals
There was an overflow or an
object is in contact with the
control panel
Clean the hob or remove the
object, and begin cooking again
C shows on the zone display
The temperature limiter sensor
has been activated
Allow the zone time to cool
down.
U flashes on the zone display
The cookware used is not
suitable for induction or is less
than 12 cm in diameter (10 cm on
the 16 cm zone)
See page 3 for information on
cooking on induction
The saucepans make noise
during cooking or your hob
makes a clicking sound during
cooking
This is normal with some types of
cookware. This is caused by the
transfer of energy from the hob
to the cookware
Nothing. There is no risk,
neither to your hob nor to your
cookware
The fan continues to function for
a few minutes after the hob is
turned off
Cooling of the electronic
components.
Working normally
Nothing.
The hob keeps blowing the mains
fuse
This is most likely to be
caused by an incorrect power
configuration setting
Refer to the instructions on
configuring your hob (page 13)
Summary of Contents for hn6410
Page 23: ...23...
