20
How to Install the Hob
1. Make the required hole in the worktop. Note that before doing this,
check the instructions supplied with any cooker hood to ensure that
you will have the required clearance. The cut-out (Fig. 11) shows a
minimum 50mm gap from the wall to the cut-out edge.
2. Position the hob seal, as shown in the diagram below (Fig. 13),
ensuring that the ends meet without overlapping. Do not use silicone
type sealant.
NOTE: The seal is supplied already fitted to the hob on some
models, for your convenience.
3. Secure the hob to the worktop using the fixing brackets and screws
supplied, as shown in the following diagram (Fig. 14). Remove any
excess seal after tightening the brackets.
Installation Dimensions (mm)
HG7250 &
HG7350
HG9350
Overall width
680
860
Overall depth
500
500
Worktop cutout width
557
837
Worktop cutout depth
477
477
