Assembly Instructions for Integrated Dishwasher
.12.
The door must be perfectly balanced. In the factory , the tension
of the springs is regulated to ensure that the door is perfectly
balanced when light wood door panels are mounted on the door.
If heavier, solid wood door panels are used, the door can be
balanced by simply turning the two screws (both screws must
be turned the same amount) located on the top part of the
machine.
Adjusting the Door Springs (Fig.6B)
Installation of Continuous Base Moulding
Position the washing machine in the cut-out in the kitchen cabinet:
1
Install the continuous base moulding , following the
manufacturer’s instructions .
2
Slowly open the door of the dishwasher to check to see if
the door strikes or rubs against the base moulding.
3
If so, rest the bottom edge of the panel on the base
moulding and mark the part to be cut. Leave at least 3mm
of the play between the panel and the base moulding
to allow for the door to rotate freely (Fig.7).
4
Remove the base moulding and trim it as needed,protecting
the surface that has been cut with a paint or similar
wood finish (Fig.7)
5
Install the base moulding again (Fig.8).
Positioning the Unit within the Cutout (Fig.10)
Push the dishwasher into the cutout opening and turn the feet to
make it level and to adjust for height so that the crosspiece (A)
for fastening it in place located on the top part of the machine
(Fig.10) comes into contact with the counter .Align the door panel
mounted on the dishwasher with the doors on the adjacent cabi-
net (2).
Adjustment of Back Feet (Fig.6A)
Insert the appliance in the cutout and then adjust the height of
the machine using the screws located at the bottom front .Use a
screwdriver to turn the screws in a clockwise direction to raise
the dishwasher and in an anticlockwise direction lower it.
How to use water-proof plastic
Firstly take off the water-proof plastic from the sticker with the
appliance (see
I=
Fig.9). Secondly stick it on the bottom of the
kitchen board (see
I=
Fig.9). All of this can avoid humidity in the
kitchen.
Notice:
If power screwdrivers are used to make the adjustment, make
the final adjustment manually with a normal screwdriver.
Important:
The dishwasher must absolutely be fastened to the counter top
to prevent the machine from tipping when the loaded dish racks
are pulled out.
GB
